2011X61 Fire in engine room

01 Nov 2011 MARS

 

 

Fire in Engine Room

MARS Report No.109 DNV

This report is reproduced with kind permission of Det Norske Veritas. It was distributed by them on their Casualty Information Sheet 7/99.

 

COURSE OF EVENTS

A fire started in the main engine room of a vessel when at sea. Both main engines were stopped by the crew. The ship had full electrical power supply during the event due to having a separate auxiliary engine room. The crew used CO2 and water to put out the fire, which was finally extinguished after about 4 hours.

EXTENT OF DAMAGE

The main engine room was entirely burnt out, including some minor adjacent compartments not protected with A60 insulation

PROBABLE CAUSE

The fire most probably started due to the breakage of a flexible hose on the low pressure fuel return piping on one of the main engines. The fuel sprayed on to a hot surface and then ignited.

LESSONS TO BE LEARNED

  • Flanges, turbine housings, clamps and various bolts and nuts on engines are to be checked for insufficient insulation.
  • Many areas on engines often prove to be hotter than expected (<2200c), such as indicator cocks, various clamps and bolts and where the insulation underneath tinplates is dislocated or not thick enough.
  • Control of flexible hoses should be included in the planned maintenance system.
  • Flexible hoses should only be applied where relative movements can be expected. Where this is not the case, steel pipes are to be utilised. Remember - flexible hoses have a limited lifetime depending on the environmental conditions they are exposed to and the medium they are applied for.
  • Fuel oil piping, including flexible hoses, are to be properly shielded.

 

 
Return to listing