202228 Engine room takes on water during repair

20 Jun 2022 MARS 2022

A vessel was moored at a shipyard to repair an exhaust gas scrubber overboard discharge pipe. As part of the repair process, divers installed a cofferdam on the outside of the ship’s hull.

Once the cofferdam had been installed, repairs started with the removal of the pipe inside the engine room. The new pipe was then fitted and partially welded to the hull. The first welding pass covered approximately 50% of the pipe circumference. The inboard flange on the new overboard pipe was tag-welded. As a new work crew came in a leak was discovered. Immediately the divers, still in the water, were informed and they attempted to close the leak at the cofferdam.

The water in the engine room bilges was rising quickly, so the general alarm was raised. About 15 minutes later, for the safety of the vessel and her crew, the Master decided to start pumping the sea water overboard through the emergency bilge arrangement. It was also decided to quickly reduce the ship’s draft aft by pumping ballast directly overboard, bypassing the ballast water treatment plant.

Local and national authorities, the company emergency response team, insurance and Flag State were promptly informed. After four hours the emergency was under control and definitive repairs were carried out as per the plan.

The investigation revealed that heat from welding could have caused deformation of the ship’s side plating, causing the cofferdam to lose watertight integrity. Also, the flat cofferdam did not form a perfect seal with the hull due to a slight curvature at that location. 

Lessons learned

  • The task was executed by an external team, resulting in limited crew participation. Close coordination and supervision of contractors by crew provides an added layer of safety.
  •  In an emergency, pumping bilge water and ballast directly overboard is allowed within MARPOL and the International Convention for the Control and Management of Ships’ Ballast Water and Sediments.